The Group Sweep function sweeps from Group 1 \u2013 Group 30.\u00a0 It stays on each frequency for 3 seconds or so, and then moves to the next frequency and it will just keep doing that.\u00a0 It takes around 15 minutes to go through the entire group SWEEP.\u00a0 You can see the frequency number change on the display screen.<\/span><\/p>\n<\/div>\n You can’t choose any specific group using group SWEEP; it goes through all of them.\u00a0 You can set this function up so it is specific to your needs.\u00a0 I just redid mine last night.\u00a0 I use this all the time.\u00a0 I have the mat under my desk with my bare feet resting on it — the machine on Group SWEEP, all day while I’m working.<\/span><\/p>\n Here is a PAGE<\/a> I did for the Blog to give you an idea of how this can be set up.<\/span><\/p>\n ——————-<\/span><\/p>\n SWEEP & Pulse SWEEP<\/b><\/span><\/p>\n The Pulse \/ Sweep function is identical to the \u201cSWEEP\u201d mode, with the exception that the machine Pulses the Group\u2019s 10 frequencies every Second, rather than the normal \u201cSweep\u201d Play-back which is 10 Minutes per frequency (non pulsed).<\/span><\/p>\n This is also good if you don\u2019t have time for a full treatment on SWEEP. If you only have 30 minutes to do a treatment you can use the PULSE SWEEP function and you will get all 10 frequencies delivered to the body for those 30 minutes, whereas if you used the SWEEP function you would only get the 1st 3 frequencies. You can pause and start back where you left off, but when short on time the Pulse SWEEP is the way to go.<\/span><\/p>\n Pulse uses a unique processor to \u201cStore\u201d and \u201cBuild\u201d the Energy in a momentary Off Position, only to Pulse this Stored Energy back into the body in a quick Sweeping motion; increasing the effectiveness of the Frequency and focusing the Waveform and moving the energy deeper in the body for more efficient healing treatments. Still SWEEP is what you want to use most of the time as Pulse SWEEP stays on each frequency for 1 second as opposed to 10min. per frequency on SWEEP.<\/span><\/p>\n RUN<\/span><\/strong><\/p>\n You can use one frequency for however long you want using the RUN command.\u00a0 That will play that one frequency that is showing on the display screen till you stop.\u00a0 Other than that you can’t manually change the time.\u00a0 You either use the SWEEP function for one specific Group, and that stays on each frequency for 10min. and then moves on to the next.\u00a0 It takes 100 minutes to go through one Frequency set on SWEEP.\u00a0 And, it will continue to SWEEP that group until you stop it.<\/span><\/p>\n —————————— RUN plays whatever frequency is showing on the display screen — till you stop it.<\/span><\/p>\n Pulse RUN does the same, but pulses the frequency every second.<\/span><\/p>\n —————————–<\/span><\/p>\n<\/div>\n<\/div>\n
\n
![\"Health](\"http:\/\/healthproducts2.com\/image\/data\/logo.png\" "\\"Health"){kind=logo}
<\/a><\/div>\n<\/td>\n<\/tr>\n