When you program you are going through these steps:
1. Power machine on
2. Push Program
3. Put in your frequency
4. Push Program again to save it
5. Push the UP arrow to go to the next frequency bank. Repeat the process till all 10 have been programmed.
Push Program and enter the next frequency,
Program again to save it and the UP arrow to advance to the next frequency bank.
You will see when the machine is in Idle mode, to the far right it will show i0
this is the first frequency bank. If you push the UP arrow while the machine is in Idle mode you will see the number change on the far right from i0 – i9.
Your mission is to program one frequency into each of those banks.
When you are in PROGRAM mode you will see that “i” changes to “P”. When in SWEEP mode it will change to an “S” and when in Run it will change to an “R”.