Colloidal Silver Information, also using the V3, V2 machines to make it.

Question:

I have tried to make colloidal silver in accordance with instructions in manual and have not detected any colloidal silver.

The manual says to look for white cloud.

 I have been using distilled water with 0 ppm and no clouds have been seen even after  6 cycle repeats of the silver program.

 I have used  a TDS meter to check for any particles and have found none using distilled water.

 In addition I have used a conductivity meter  and reading was also 0.

 This meter was calibrated by another silver generator supplier to detect colloidal silver.

When I use tap water I do see a cloud but then the tests are useless for verifying the silver, due to all the other particles in city drinking water.

I assume that generation of cloud in city drinking water would indicate current is being passed.

Please verify that distilled water is to be used with nothing else added.

And shouldn’t I see an indication that the Colloidal Silver is present?

Please pass this on to your engineers and get their advice and any additional  instructions  for using the silver program.
Answer:

The water is so pure it is creating difficulties for the machine to produce the silver colloids.

Solution:  Reduce the size of the glass to a smaller glass.  Add a pinch of pure salt to the distilled water.  Let the salt dissolve, and try again with the colloidal silver maker.

– Note:  On the Beck Machine, Run the Silver program multiple times.  Sometimes only once or twice will not produce enough colloidal silver.

Solution 2:  We have been told that Rife Digital V2 & V3 owners used the Rife Machine with the Beck Machine Colloidal silver accessory, using the Super Sweep program, and produced colloidal silver very quickly. 

However note that Rife Digital Professional V2/3 uses a higher power output, so a PPM meter should be used to check strength. 

Colloidal Silver will be made extremely fast with the Rife Digital


Simply plug the RCA Colloidal silver attachment shipped with the Beck Professional machine, into the RCA jack on the V3​ or V2.

Run the SUPERSWEEP program on the R​ife ​D​igital ​​Professional ​V2/3 

Use a PPM meter (which the customer does have) to set the desired Colloidal Silver PPM rate

Question:  Where do I buy this PPM meter from?

About $15 bucks on amazon

 

Question:  What is the best PPM for colloidal silver?

30​ ​PPM for a low/normal dose  40PPM middle  60PPM strong dose

 

​————–

Link to the Healthproducts2 Home:
DISCLAIMER

Leave a Comment

Your email address will not be published. Required fields are marked *

Shopping Cart
Scroll to Top