Question: Can I can some information about using a multimeter or Oscilloscope? Answer: Testing using a Multimeter https://rifeandzappers2.com/cw-and-the-oscilloscope-bandwidth/ https://rifeandzappers2.com/multimeter-vs-oscilloscope-power-question/ https://rifeandzappers2.com/how-do-i-test-the-voltage/ Link to the Healthproducts2 Home: DISCLAIMER
Testing the Machine Read More »
Question: We have the 16V model and have used it so many times. The voltage was actually about 5.4 – and we have many different kinds of Zappers and we tested them as well and they tested below 5 – each of them. Answer: The true voltage is around or above 10v which is
How Do I Test the Voltage? Read More »
Question: I know I have a 17v machine, but that’s not what I see when I test the voltage with my Multimeter. Any thoughts? I used to feel it when I put my tongue to the lead, I still do but not as much. Answer: Lower frequencies tend to have a punchier buzz than the
Multimeter vs Oscilloscope — power question Read More »
Question: Hi Michele have been using the rife machine ‘properly connected’ since Nov 30 but today decided I should test its function with the multimeter which is an electricians high end one, Digitech QM1530. The results (following your instructions) were thus: RIFE MULTIMETER READING 437.80 not reading. 18 .19 .06 .08 2.75 2.75 222.72 222.40
Testing with a Multimeter Read More »
To use the Multimeter you want one that has a Hz setting. You would put that to the Hz setting. Have the leads connected to the machine; The machine turned on to a frequency using the Run command Then make sure the output light is on; Then put the positive probe on the positive strap
Testing using a Multimeter Read More »