Question: G’day to you. Do you offer any of your products in a downloadable form to be operated on a computer in an audio version with headphones? Answer: No we dont provide audio frequencies for this reason: A computer is limited with frequency output to Max 24Khz A standard computer audio board (sound card), and […]
Does it have s Sine Wave/Square wave output? Wave output is SQUARE only, switching to SINE will invalidate the effectiveness of the treatment. SINE waves should never be used unless in conjunction with a Bulb Light. Does it have a Dual frequency output mode for Radio & Audio? There is DUAL output as
Sine or Square Wave, Audio, CW, RF, 1MHz Read More »
Question: Can I use the machine with speakers to provide an audio output? Answer: You can hook the RCA cables to a speaker for Audible output. That is possible However the AUDIO frequencies through speakers have not been trialled or tested yet, as far as I know Dr Rife did not appear to consider this
Can I use the machine with speakers? Read More »
Question: I purchased one of your Rife machines and I’m happy with it, but I would like to know more about how to treat nerve damage from a skull fracture. Also I have questions about getting an attachment to make audio frequencies. Is it possible? Answer: We do not have a Speaker accessory for Rife
Nerve Damage and a question on Audio Frequencies Read More »
Question: I like your appliance devices. I am an experienced electrical/electronics engineering technician. I’m asking a very precise, technical question, because I would like to connect my carbon impregnated electrodes to the V2. Are the feet/hand straps, belt and/or mat connected to the instrument with 2 conductors? Even if it,s a coaxial cable (that’s 2
CW, RF, Audio, Alternative Connection Read More »
There is a belief that the audio frequencies that were used in the original Beam Rays Clinical Rife Machine and its 1940’s and 1950’s AZ-58 replica Rife Machines are harmonic M.O.R. frequencies derived by dividing Dr. Rife’s original high RF frequencies down in octave steps until you reach the audio range of frequencies. For this
Carrier Wave & Technical Information Read More »
Question: The Zapper Digital Series says that it uses the Rife Carrier wave. However it is 3.3 mega Hz and your machine is only producing 1 Mega Hz. Answer: There is a belief that the audio frequencies that were used in the original Beam Rays Clinical Rife Machine and its 1940’s and 1950’s AZ-58 replica
CW, RF, Audio – can you explain? Read More »