Rife Digital MachineUSER-friendly USER-Instructions This document is a supplement to the User Manual included with your machine. Our hope is to clarify. Contents Introduction Quick Start Machine Modes How to Program General Recommendations Serious Disease Treatments Will I feel anything – maybe yes, maybe no Frequencies Warnings 1-4 Non-Concerning Information Frequently Asked Questions – please go to page 11 of the Quick Start Manual. Frequencies – all 3500 frequency sets are listed in your instruction book on page 59. Electro Therapy Introduction Electrotherapy can be used to fight certain viruses, bacteria, parasites, etc. Everything around us already has an electrical charge and thus a certain electrical frequency – we are always and everywhere exposed to it. If you have a specific virus, it lives in a given frequency field. Let us assume for simplicity that it lived only at one single electrical frequency. When you feed the same frequency generated by an electro-therapy device to your body, the virus gets over-stimulated and dies. Quick Start Your machine comes pre-programmed with 10 general frequencies – so feel free to start right up and use the machine. Actually, spending the first three days using the pre-set frequencies will help eliminate common problems.
- Plug in Power to wall
- Plug in power to transformer
- Plug in transformer cable to frequency generator
- Plug in strap cables to frequency generator
- Attach Straps to cables
- Put on Straps as directed in the manual.
- Turn on machine and push Sweep or Run
MODES I = Idle Mode Idle mode is exactly that – the machine is not running. From Idle mode you can move to different frequencies and/or program in new frequencies. R = Run Mode Run Mode is the setting that runs only the frequency that is showing on the device. In Run mode, the machine will run at that frequency until you shut it off. S = Sweep Mode Sweep mode is the setting that will run each frequency in order for 10 minutes each. This is called a session. The machine does not stop at that point, but will begin again to run through the 10 frequencies indefinitely – until you shut it off. P = Program Mode To program the device for different frequencies we offer lots of help, although it is very easy. We have created a YouTube video that is helpful – http://www.youtube.com/watch?v=ilg5xILGfBk How To Program
- Use the up or down arrow to choose the frequency you want to change.
- Push the word ‘program’.
- The cursor will flash on one number and you can change it by using the up or down arrow. Right and left arrows will take you to the next number.
- Push program again to save (screen will say “wait”).
- Up arrow will take you to the next frequency to change.
- Repeat 2-5.
- Or call 206-708-6408 for customer support.
General Recomendations: Do not change the programs too often, but focus on one disease that you want to treat with one Frequency Set. Conduct regular treatments (5 days with 2 days rest), until your symptoms have disappeared. Sometimes it is recommended to use 2 different frequency sets for one particular illness; in this case switch between the 2 sets in weekly intervals. If you do not feel any change within 5 days, then you probably are working with the wrong frequency set and should try something different. The programmed frequency set of 10 frequencies is stored on a built-in memory card and remains the default program even if you turn it off. You can reset the frequencies to their factory default settings. To do that – start when the machine is off. Press Program and then turn on the machine while still pressing program. Lift off program and the machine will revert to the factory setting. If new to this form of therapy or if you have not used an electro-therapy device for a long time, we recommend starting the treatment slowly. In the ‘Sweep’ Mode, run a maximum of one cycle a day, possible divided in two sessions (first 5 frequencies, then a few hours later, the other 5). If you regularly work with the device, you can start treating overnight with attached foot-straps. This way you accomplish 3-5 cycles during sleep and will experience very immediate healing successes. Generally speaking, sleep is not disturbed; many users even describe quite the contrary; they feel more clear and more alert after nights on electro-therapy treatments. After a few days with this rather conservative treatment, you can increase the treatment time to 2 ‘Sweep’ cycles per day. If you would like – overnight treatments are OK at this point. Serious Disease Treatments More serious diseases often require a longer treatment period, and often permit a course of frequencies that may change every few weeks. Our devices have been used successfully to treat serious diseases for thousands of people. Time and again, the results have shown that the extended treatment sessions have produced the best healing responses. Extended sessions are more convenient at night, so as not to interrupt daytime activities or work schedules. An overnight session with the straps attached to the feet will permit a deeper healing which will reach and penetrate the organs of the body. For example, the intestines are an organ that could previously not be reached by early frequency devices; now with the electro-therapy device, one can eliminate parasites and pathogens that inhabit the intestine and other organs such as the liver, kidneys, gall and stomach. However, it does take time, and you are required to use frequencies that resonate closely with the pathogen or parasite involved. We recommend the ‘sweep’ mode for this purpose as it scrolls through the 10 frequencies every 10 minutes in a loop cycle. Each frequency resonates with the healing program in order to treat the particular disease condition. Because the electro-therapy device works using natural frequencies, three months may be a plausible time period for a remission of more serious disease conditions. Natural medicine works in this manner, on a more subtle level and over an extended period of time. Again, best results are achieved with the extended overnight treatment sessions. Will I Feel Anything – Maybe Yes, Maybe NO hen you begin the electrotherapy treatments, many parasites and pathogens are killed. This can overwhelm your immune system and lead to nausea, fatigue and dizziness. This is called the ‘Herxheimer effect’, or ‘parasite die-off syndrome’, an immune system response to toxins in the blood and tissues. This brief overloading of the liver and other eliminating organs worsen your symptoms at first. This can be for a few hours, but can also last up to 2-3 days before you begin to feel much better. It is important to know that the worsening of symptoms does not mean the treatment has failed; in fact, it is exactly the opposite, namely the evidence for a very strong and effective detoxification. The most important thing is to accept this physical reaction as a confirming result of the treatment. If it is very severe, then reduce the time of treatment, drink lots of water (at least 4 quarts) and rest. Do Not Exercise. Eat lightly to not burden your digestive system additionally, add freshly squeezed lemon juice to your drinking water and make sure that your digestion system is working properly (using Epsom salt or natural laxatives may be recommended). Take a rest from the electro-therapy sessions for a few days until you recover. FREQUENCIES The book lists thousands of diseases and ailments along with their accompanying 10 frequencies. Sometimes, the choice is simple, for example if you have a cold then simply program your device with the frequency set for ‘common cold’ and set your machine for ‘Sweep’. More complicated disease conditions may require an individualized program. How to Choose your Frequencies: If you do not know your particular issue, there are a couple methods you can use to determine what frequencies you can use. Most involve a visit to a natural health-care practitioner.
- Kinesiology Testing
- Bioresonance (or Bio-Feedback) Testing
WARNINGS AND NOTES NOTE: You cannot do anything wrong with these treatments. If you use the device to eliminate a particular parasite, and you do not have this parasite, then the electrical frequency will simply fade without effect on the body. Warning One: Use Straps only in the Palms of Hands or on the Soles of your Feet. See quick start (p.10) for picture. When using the Frequency Generator you may experience a tingling sensation on your skin. This is unlikely to happen in the palms of your hand. However, on sensitive skin, like the underside of your wrist or your stomach, this tingling may occur. Leaving the strap terminal on your sensitive skin will result in a rash, so do not leave on softer skin if you feel this tingling sensation. One of the best places to conduct treatment sessions for longer periods (hours) is to place the straps over your foot, so that the metal button touches the under sole of your left and right feet. The under-soles of your feet have tougher skin and will be able to bear the extended periods of electro therapy. We suggest connecting the straps only to the soles of the feet with the blue/green conductive strap facing the underside of the foot and the stainless steel button making contact with the soles. Warning Two: It has been suggested that Pregnant Women should not use the electro-therapy device. Warning Three: Do not use if you have a Pacemaker Non-Concerning
- Use with a metal heart stint is OK.
- Use with any other metal part is OK – knees, hips, etc.
Link to the Healthproducts2 Home: | |
DISCLAIMER |